5
9
10
11
COMMISSIONING
Finally carry out a general functional test and perform the basic and car specific settings (AC, OPS etc.).
Also ensure that no fault warnings appear on the vehicle side.
11. The installation of your Z-E3150 is now
complete.
●
Make sure that all connectors at the rear of the ZENEC system have sufficient room and are not bent.
● Connectors without a retaining mechanism must be additionally secured with insulating tape.
10. Neatly arrange the wires to the side, making
room for the ZENEC system. Carefully slide
it into the radio slot. Push back the Z-E3150
until you hear the clicking sound of the latching
mechanism.
9. Connect all the cables to the ZENEC system
(No. 1) those previously run in the radio slot,
and the original antenna cables.
NOTE
