4
8
7
INSTALLATION:
4. (No picture)
Install the GPS antenna (No. 2) in a suitable
position, making sure that the GPS reception is
not adversely affected by unwanted shielding
of metallic vehicle parts (thermal insulation
glazing, etc.). Then route the connection cable
into the radio bay.
5. (No picture)
If you have purchased the optional external
Bluetooth microphone (N-ZENC-MIC), install
it now and route the connection cable into
the radio bay. Depending on your preference,
and whether you select an internal or external
microphone, the microphone source for
Bluetooth mode must be set accordingly in the
unit menu.
6. (No picture)
Route the USB extension cable´s (No. 7) from
the radio bay to your preferred position.
7. Connect one of the main connection cables
(No. 4) of the ZENEC system (No. 1) to the
Quadlock connector of the car and close its
locking mechanism. Following this, connect the
CAN bus interface (No. 5) to the main connec-
tion cable.
8. Before installing the ZENEC system (No. 1)
remove the two transport securing screws.
