Zenbooth Solo, Build Instructions

Page: 37 / 40

037
// TROUBLE SHOOTING
Q: The Door “scrapes” across the bottom of the booth.
A:
Insert shims into rear right corner of the booth (see diagram on page 33)
.
Q: “The Door does not close by itself, is that normal”?
A:
Repeat step 23 again, tightening the spring another notch.
Q: My fan/light stays on continually.
A:
If the timer does not seem to be turning the product off after 10 minutes, please contact Zenbooth
support.
Q: My booth is stuffy or warm.
A:
Ensure the fan is unobstructed and at least 4” from a wall or structure. If it is obstructed, clear the
obstruction or move the booth. If this does not fix the problem, ensure the booth is plugged in and
the fan is operating normally.
Q: The desk lift stopped operating. What can I do?
A:
First check if it is plugged in and the booth has power. If your booth has power, then it is possible
the controller in the desk needs to be reset. Perform the following steps, to reset:
- hold the down button until desk goes all the way to bottom (should take a second)
- once at the bottom, let go and hold down button again (desk should drop another 7mm)
- once it hits that 7mm it should be reset.
Q: I am standing in the booth and feel cold. Is there a possible fix?
A:
The booth exchanges air from the outside in. To ensure a comfortable experience, make sure that
the outside temperature in your office is also at a comfortable level. If this is not ideal, then a small
space heater inside the booth can help keep the temperature at a comfortable level. At no time should
you obstruct or tamper with the booth’s ventilation system.