TABLE 1 – ZENAIR INSPECTION FORM
Make / Model
ZENAIR CH2000
Serial No.
Airframe Hours
Type of Inspection
(Circle One)
Registration No:
Engine Hours
50 100 500 1000
Symbols: + Indicates perform task, - Indicates do not perform task
Task
Refer to
Intervals
(Flight Hours)
Initials
50
100
500
1000
14. Inspect safety belts, attaching
hardware, etc. for condition security.
15. Verify appropriate compass correction
card is in aircraft.
16. Clean or replace filters in the gyro
vacuum system (if installed).
17. Inspect radio installations and
mounting hardware for security,
condition. etc.
18. Inspect electrical wiring for condition,
security, routing, damage, etc.
19. Check condition and security of all
bonding wires.
20. Inspect antenna installations for
condition, security, etc.
21. Inspect instruments for security,
markings, condition and perform
operational check.
22. Inspect fuel sender unit for security,
leaks, etc.
23. Inspect fuel primer (if installed) for
security, condition, leaks, etc.
24. Check brake fluid level section V.
25. Inspect the aft side of the firewall from
inside the cabin for cracks around any
rivets.
Landing Gear Group
1. Inspect the main landing gear
mainspring attachment bolts for proper
torque, safeties, etc.
Section IX
Section IX
Section IX
Section VIII
Service bulletin
No. 00-03
Section V
+
-
-
-
-
-
-
-
-
+
+
-
-
+
+
+
+
+
+
+
+
-
+
+
+
+
+
+
-
+
-
-
+
+
-
-
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
3.6
Nov-02
