66
FILTER DISASSEMBLY
FOAM FILTER I
1
Open the lid of the filter unit by pulling the handle
upwards.
2
Take out the filter, wash it under running water, dry and
reinsert.
Close the filter unit lid by pressing it until you hear
●
a characteristic click.
FOAM FILTER II
It is recommended to wear rubber protective gloves while
dismantling the filter.
1
Grab the foam filter with your fingers and remove it from
the filter unit body.
2
Wash under running water, dry and reinsert.
ATTENTION! Do not hand wash the filter foam, do not
wring it, do not wash it in washing machines. Avoid
crumpling, stretching and deforming. After cleaning
dry the foam in room temperature. Never dry the foam
on heaters, stoves, etc.
INLET FILTER
1
Remove the SAFBAG
(21)
dust bag module from the
container.
2
Take out the SAFBAG dust bag from the module (see
chapter TRADITIONAL CLEANING WITH SAFBAG DUST
BAG -disassembly/assembly of the SAFBAG dust bag).
3
Release the fastening hook which fixes the lid of the
SAFBAG dust bag module with the basket and pull the
basket aside.
4
Take out the filter, wash it under running water, dry and
reinsert.
Close the basket of the SAFBAG dust bag module by
●
pressing it until you hear a characteristic click.
Insert SAFBAG dust bag (see chapter TRADITIONAL
●
CLEANING WITH SAFBAG DUST BAG –disassembly/
assembly of the SAFBAG dust bag).
HEPA OUTLET FILTER AND COOLING AIR FILTER
The HEPA outlet filter should be replaced after about 30
hours of operation (6 months) or earlier in case of heavy dirt.
1
Slide the slider of the filter cover interlock downwards
and open the filter cover.
2
Remove and replace the HEPA filter with a new one
when the filter becomes dirty.
3
Remove and replace the motor filter with a new one
when the filter becomes dirty.
4
It is possible to rinse the HEPA filter and the cooling
air filter under running water. Remember to dry the above
mentioned filters before reassembly.
Close the filter cover and slide the interlock slider
●
upwards.
Ecology – environment protection
Each user can protect the natural environment. It is neither
difficult nor expensive.
In order to do it: put the cardboard packing into
recycling paper container; put the polyethylene
(PE) bags into container for plastic.
When worn out, dispose the appliance to
particular disposal centre, because of the
dangerous elements of this appliance, which
can be hazardous for natural environment.
Do not dispose into the domestic waste disposal!!!
The manufacturer does not accept any liability for any damages
resulting from unintended use or inappropriate handling. The
manufacturer reserves his rights for modifying the product any time
in order to adjust it to law regulations, norms, directives, or due to
construction, trade aesthetic or other reasons, without notifying it in
advance.
H
I
J
G
Summary of Contents for Aquawelt 919
Page 37: ...41...
