45
Fan base and stand assembling
1. Remove the base
(16)
and stand
(15)
from the package.
2. Fasten the stand
(15)
in the base
(16)
with a bolt connecting the base with stand
(17)
.
3. Take out the inner tube for desired height and screw the height adjusting ring
(14)
.
4. Place the assembled fan casing on the stand
(15)
and fasten it screwing the bolt fastening the fan motor with the stand
(11)
including nut
(13)
in
narrow area
(12)
.
Make sure, that all elements are assembled correct.
Handling and operation
Insert the plug of the supplying cord
(9)
to the mains supply outlet.
Smith on the fan turning the speed rotation knob
(6)
into selected position.
You can set the following rotation speed with rotation speed knob
(6)
:
The fan is on.
The fan works on the lowest rotation speed.
The fan works on the medium rotation speed.
The fan works on the highest rotation speed.
You can change rotation speed during operation.
The fan can operate in two modes:
static,
–
oscillating.
–
To start up oscillating mode press the by oscillation rod
(7)
in. In order to stop oscillation pull oscillation rod
(7)
out.
The airflow direction can be adjusted vertically with head setting knob
(10)
. In order to do it, release the head setting knob
(10)
turning it counter
clockwise. Set the head at desired angle and block it turning the head setting knob
(10)
in clockwise direction until it runs.
Cleaning and maintenance
1. Make sure to unplug from the electrical supply source before cleaning.
2. Plastic parts should be cleaned with mild soap and a damp cloth or sponge. Thoroughly to remove soap film with clean water.
3. Dry thoroughly; make sure that water or other liquid did not get inside of motor.
Summary of Contents for 24Z014
Page 47: ......
Page 48: ...GW24 010 ...
