Zelmer 24Z011, User Manual

Page: 35 / 40

35
4. Remove and throw away plastic bushing located at the end of the motor shaft.
5. Insert the motor blades ( 4 ) on the shaft.
6. Screw the hub housing ( 3 ) counter-clockwise until it runs on
the motor shaft.
7.
Fasten front housing (
1
) back housing (
6
), inserting safety
ring ( 2 ).
8. Tighten the screws of safety ring ( 2 ).
Check if all elements have been assembled properly!
1. Unscrew hub housing ( 3 ) and plastic nut ( 5 ) of the front part of motor casing ( 7 ),
remove both parts.
2. Fasten the back housing ( 6 ) in right position – handle upright.
3. Tighten plastic nut ( 5 ) clockwise until it runs, on the trash protrud -
ing out of the motor casing ( 7 ).
FAN OUTLINE
1. Front housing.
2. Safety ring.
3. Hub housing.
4. Fan blades.
5. Plastic nut.
6. Back housing
7.
Motor casing.
8. Supplying cord.
9. Column.
10. Base.
11. Fastening nut.
12. Height adjustment ring.
13. Control panel.
14. Remote controller.
The product you purchased is partially disassembled.
Assemble thoroughly before usage according to the
following description.
COLUMN ASSEMBLING (9)
1.
Remove the parts from the package: column (
9
), base (
10
) and loose the fastening nut (
11
).
2. Fasten the column ( 9 ) in base ( 10 ) with the fastening nut ( 11 ). Unscrew and remove height ad -
justment ring from the elements of the column.
3. Take out inner part of column to adjust selected height and tighten height adjustment ring ( 12 ),
to fasten it in right place.
4. Place the motor casing ( 7 ) on the column ( 9 ) and fasten it tightening a screw. The screw is lo -
cated at the back of column and motor casing connection point.
FAN CASING ASSEMBLING