18
1. Check the new oil bottle, make sure that the PAG oil is more than 50ml inside.
2. Use
or
to adjust the oil quantity, then press OK, it will finish
automatically. Or long press
key, the new PAG oil would be sucked
into the A/C system. Watch the scale of the PAG bottle, when the oil is added with
the desired quantity, stopped the operation.
3. Press
key back to the standby mode, continue the next process.
7.4 Recharge
This operation is to fill with the refrigerant into the vehicle A/C system
though the Air-Con Service Station. the quantity is measured by load cell and it
must be a vacuum state that the gas could be added into the A/C system.
For this operation, the work tank should have at least 3 kg gas inside.
Usually, if the tank pressure is over than 6 bar, the recharge will be done
quickly, or it need some special solution to resolve it.
1. Press
key to come to recharge process.
Note: The highlight "G" at the lower right corner is the prompt that means you could specially
recharge the gas by long pressing
key.
the charge only from the low side port.
And the gas quantity can not be measured.
RE CH ARG E
D E FAU LT * * * *G
PRE S S F K E Y TO U SE
D ATAB ASE !
G
OIL INJECTION
INJECTION 20 ML
PRESS OK TO START