15
Restoring the DVS5.1 to Factory Defaults
Restoring the DVS5.1 to the factory defaults
Resetting the DVS5.1 to the factory defaults is done by removing power to the DVS5.1. The AC wall
adapter must be unplugged, so that the DVS5.1 is completely without power. The
SETUP
key is
then pressed and
held
while power is restored to the DVS5.1. After about three seconds the power
indicator will flash three times indicating the DVS5.1 has been reset to factory defaults.
S
TEP
1
1
Remove all power from the DVS5.1. This can be done by
unplugging the AC wall adapter from the back of the DVS5.1, or
unplugging the AC adapter from the wall, or by using a switched
power strip. Nothing should be lit on the DVS5.1.
S
TEP
2
2
Using a pen or pencil, press AND HOLD the
SETUP
button on the
back panel of the DVS5.1. While continuing to HOLD the
SETUP
button, reapply power to the DVS5.1. When power is applied, the
power indicator light will light up indicating standby mode.
S
TEP
3
3
Continue to HOLD the
SETUP
key and after about three seconds
the power indicator will blink three times indicating the DVS5.1 has
been reset to its factory defaults.
The DVS5.1 factory defaults, are:
• Control codes used are the Awia DVD codes.
• Default power up mode is standby.
• Default selected input when powered on is input 1.
• Default brightness mode is Auto-dimming.
4
5
Audio
3
2
1
ZEKTOR
4
5
Audio
3
2
1
ZEKTOR
4
5
Audio
3
2
1
ZEKTOR