Zeiss VISUREF 150, User Manual

Page: 68 / 134

Operation of the device
000000-2227-967-GA-GB-281021
62
•
The recorded measured values will be displayed in white columns for the
right (OD) and left eye (OS). Between the columns you can see the
measurement parameters ( 5 , Fig. 33).
•
If only one measurement sequence is performed per eye, the AVG
indicator ( 3 , Fig. 33) will not be displayed. If more than one
measurement sequence is performed, the AVG indicator will be
displayed on the right or left upper edge of the measurement column.
This indicates that the displayed values are arithmetic mean values of
the total measurement sequence.
•
If a measurement sequence is recorded from several single
measurements, the single measurement values of each parameter and
each measurement within this measurement sequence can be displayed.
– The detailed display ( 7 , Fig. 33) can be opened by tapping on the
desired measurement value in the corresponding column ( 8 , Fig. 33).
The latter shows all recorded measurement values of this parameter in
this sequence. In Fig. 33, seven measurements have been performed.
– By tapping the direction arrow ( 4 , Fig. 33) you can see the results of
all single measurements. In Fig. 34, for example, the first of seven
measurements is shown.
– Deletion of single measurement values is described in Section Delete
measurement data , page 82.
Fig. 34 Display of measurement results of a single measurement (review screen)
•
If the illumination parameters of the device have been changed (see
Section Setting the illumination parameters , page, 54), these are
displayed beside the overview columns of measurement values (Fig. 35).