Estativo M LED
MONTAJE DE LAS ILUMINACIONES DIASCÓPICAS M LED
ZEISS
06/2016
435425-7144-008
3
Es
pa
ñol
3
MONTAJE DE LAS
ILUMINACIONES DIASCÓPICAS
M LED
PRECAUCIÓN
Apagar el estativo y sacar el cable a
alimentación eléctrica del mismo antes
de montar la iluminación diascópica.
3.1
Montaje del módulo diascópico
de campo claro M LED
•
Sacar el cable de alimentación eléctrica del
estativo.
•
Inclinar cuidadosamente el estativo hacia atrás
y echarlo.
•
Destornillar el tornillo Allen SW 3 (Fig. 2/
1
) y
colocarlo a un lado.
•
Retirar las cubiertas (Fig. 2/
2
y
3
).
•
Colocar el módulo diascópico de manera que
ambas espigas (Fig. 2/
4
) encajen en las
cavidades (Fig. 2/
5
) que se encuentran en la
parte inferior del estativo.
•
Colocar el módulo diascópico contra la placa
del estativo y sostenerlo.
•
Atornillar el tornillo Allen SW 3 en el agujero
roscado (Fig. 2/
6
) del estativo hasta que la
punta del tornillo entre en la perforación del
módulo diascópico.
•
Apretar el tornillo Allen a mano.
•
Volver a colocar horizontalmente el estativo,
ajustando, de ser necesario, la pata del mismo
(Fig. 2/
7
) para que adquiera estabilidad.
•
Volver a enchufar el cable a alimentación
eléctrica al estativo.
Fig. 2
Montaje del módulo diascópico de
campo claro M LED