Zeiss opmi lumera 700, Instructions For Use Manual

Page: 19 / 236

Instructions for Use 2 Safety notes
OPMI LUMERA 700 2.5 Electromagnetic compatibility
G-30-1673-en - 14.0 - 2018-07-12 19 / 236
Transport
u
Only transport the device over long distances (e.g. relocation,
return for repair) in its original packaging or special return
packaging.
u
Please contact your dealer or ZEISS Service for this purpose.
2.5 Electromagnetic compatibility
The device is subject to special requirements regarding electromag-
netic compatibility (EMC). The following factors can cause EMC
disturbances:
• Portable and mobile HF communication equipment in the
vicinity of the device.
• Other devices set up in the vicinity or stacked together with the
device.
• Accessories, cables and spare parts not specified in the Instruc-
tions for Use and not sold by ZEISS as spare parts.
You can prevent EMC disturbances by using the following precau-
tionary measures:
u
Please comply with the Instructions for Use.
u
Observe the EMC guidelines in the Technical Specifications
chapter.
u
Only use accessories, transformers, cables and spare parts
specified in the Instructions for Use or approved by ZEISS for
this device.
u
If you are using radio communication equipment or compo-
nents for radio transmission: Keep a distance of 30 cm to all
components of the device.
u
If you are installing the device near or stacking it with other
devices: Check to make sure the device is operating correctly in
this configuration.
2.6 Requirements for operation
2.6.1 Before commissioning for the first time
Installation performed by technical personnel or ZEISS
Service
Please make sure that the following requirements continue to be
met for further operation:
u
Make sure that the connecting components are properly set
and that all screw connections are securely tightened.
u
Make sure that all cables and plugs are in proper condition.