Zeiss KSK 150 FC, Instructions For Use Manual

Page: 62 / 92

Care and Maintenance KSK 150 FC
Version 7.1
Page 62 G-30-1158-en
Changing the halogen lamp
• Switch off the system at the power switch (1).
• Open cover (3) of the halogen illumination on the carrier arm
by turning securing screw (4) counterclockwise until the cover can be eas-
ily folded downwards.
• Allow the defective halogen lamp to cool down, if required.
• Pull the defective halogen lamp out of the ceramic base (5).
Make sure not to touch the lamp bulb or the inside of the lamp reflector
of the new halogen lamp.
• Insert the two contact pins of the new halogen lamp into ceramic base (5).
• Close cover (3) of the halogen illumination on the carrier arm:
fold the cover upwards and turn securing screw (4) clockwise until the
cover is firmly closed.
• Turn on the unit at power switch (1).
• Use adjustment knob (2) to set the required brightness.
NOTE Risk of burns caused by hot lamp!
R054
If you change the lamp shortly after it has failed, the lamp will still be very
hot. There will be a risk of being burned!
• Allow the lamp to cool down before removing it.
• Use heat-resistant protective gloves when replacing the lamp!
WARNING Electric shock!
R055
In case of a technical fault, line voltage may be present at the lamp module.
If the user touches it, he can receive an electric shock.
• Always switch off the power switch before working on the lamp module.
CAUTION Risk of burns caused by use of incorrect lamp!
R089
If an incorrect lamp is used, unwanted radiation may be emitted, and this can
cause burns.
• Only use the halogen light indicated in the order data.