Installation
¾
The camera is powered by the FireWire hub. The hub must therefore be
connected to the power supply. If you switch off the FireWire hub, the
camera is also switched off.
¾
When the power supply of the FireWire hub is connected, the red LED of
the FireWire hub lights up. The green LED of the FireWire hub lights up as
soon as a FireWire device is connected.
¾
The AxioCam MR has been designed for continuous operation. During
operation the camera may heat up. This is quite safe, and does not in any
way impair the functioning of the device.
léÉê~íáåÖ=íÜÉ=Å~ãÉê~=çå=~=åçíÉÄççâ=ïáíÜ=
çåÄç~êÇ=cáêÉtáêÉ=áåíÉêÑ~ÅÉë=
`çååÉÅíáåÖ=íÜÉ=Å~ãÉê~=íç=íÜÉ=åçíÉÄççâ=
Lay the data cable carefully between the camera and the
notebook. Make sure that the cable is a safe distance from hot
light sources on the microscope, to prevent it being damaged by
heat.
To ensure the efficient use of energy resources, the FireWire slots
on the notebook are not designed to supply power to peripheral
devices. A FireWire hub should therefore be used to supply power
to operate the AxioCam MR on a notebook.
The following components are required:
FireWire hub with power supply (order number: 000000-0452-376)
6-pin to 6-pin FireWire cable (supplied with the AxioCam MR) to connect
the AxioCam MR to the FireWire hub.
4-pin to 6-pin FireWire cable (supplied with the FireWire hub) to connect
the FireWire hub to the notebook.
AxioCam MR Instal Reference
15