Zehnder Rittling ComfoFond-L Series, Installer Manual

Page: 77 / 92

13 - EN
5.4 Adjusting the control temperatures
The ComfoAir Luxe switches the circulation
pump of the ComfoFond-L on and off at pre-set
temperatures. These desired temperatures can
be set in the P-menus “P62” and “P63” of the
ComfoAir Luxe.
In the Winter mode, the ComfoAir Luxe will
switch around the temperature that is set in
P-menu “P62”.
The best setting for P-menu P62 is a few
degrees below the lowest brine temperature.
The lowest brine temperature is a few
degrees above the average local annual
temperature;
In the Summer mode, the ComfoAir Luxe will
switch around the temperature that is set in
P-menu “P63”.
The best setting for P-menu P63 is a few
degrees below the set comfort temperature
of the ComfoAir Luxe.
The minimum and maximum values for the
available settings parameters are preset in
the software of the ComfoAir Luxe.
The circulation pump of the ComfoFond-L will
be activated if:
The temperature sensor of the
ComfoFond-L measures a temperature lower
than the temperature that is set in menu P62
when in Winter mode;
The temperature sensor of the
ComfoFond-L measures a temperature
higher than the temperature that is set in
menu P63 when in Summer mode.
The circulation pump of the ComfoFond-L will
be deactivated if:
The temperature sensor of the
ComfoFond-L measures a temperature
higher than the temperature that is set in
menu P62 when in Winter mode;
The temperature sensor of the
ComfoFond-L measures a temperature lower
than the temperature that is set in menu P63
when in Summer mode.
An installation report has been included at
the rear of this manual which can be used to
note the set temperatures.
Adjusting temperature via display
1. Press ‘
OK
MENU
·
· ·
’.
- ‘P2’ will be displayed on the screen.
2. For 3 seconds, press simultaneously on
‘
OK
MENU
·
· ·
’ and ‘
OK
MENU
·
· ·
’.
- ‘P3’ will be displayed on the screen.
3. Press ‘
OK
MENU
·
· ·
’ 3 times.
- ‘P6’ will be displayed on the screen.
4. Press ‘
OK
MENU
·
· ·
’.
- ‘P60’ will be displayed on the screen.
5. Use ‘
OK
MENU
·
· ·
’ to select the desired P-menu
(P62 or P63).
6. Press ‘
OK
MENU
·
· ·
’.
- Current setting of selected P-menu will
be displayed on the screen.
7. Use ‘‘
OK
MENU
·
· ·
’ or ‘
OK
MENU
·
· ·
’ to select the desired
temperature.
8. Press ‘
OK
MENU
·
· ·
’.
- ‘P60’ will be displayed on the screen.
9. Press ‘
OK
MENU
·
· ·
’ 2 times.
- Current ventilation setting will be
displayed on the screen.
10. Note the set values on the rating plate of
the ComfoFond-L and the installation report
in the back of this manual.