26
5. Now you can lift the upper part of the EPP-casing upwards. Ensure that the possibly assembled air
ducts for the two-room connection are thereby not damaged.
6. The enthalpy exchanger cannot be pulled upwards.
7. Clean the enthalpy exchanger if required.
In order to do so, proceed as follows:
•
For this immerse the enthalpy exchanger few times in warm water (max. 40 °C).
•
Rinse the enthalpy exchanger in the end basically with warm duct water (max. 40 °C).
As a general rule, do not use any aggressive or dissolvent detergents!
•
Position the enthalpy exchanger for drying such that the available residual water can flow from the
opening.
Hints for proper cleaning can also be found at the manufacturer’s website (
www.paul-
lueftung.de
).
8. After inspection, mount all parts in reverse order.
Summary of Contents for ComfoAir 70
Page 2: ......
Page 32: ...32 3 5 2 Assembly Template measured Figure is not scaled...
Page 43: ......
