Zehnder Rittling ComfoAir 200, Instruction Manual, Page: 13 / 52

2
For the user - 9 - EN
4. Press ” “.
– Wait until the programme position is fl ashing in
the bottom right-hand corner.
5. Select the desired programme position using
" " or "
".
6. Press " ".
– Wait until the hour, e.g. “ 7 ”, starts blinking.
7. Select the desired start time in hours using "
" or " ".
8. Press " " .
– Wait until the minutes , e.g. " 00 ", starts blink-
ing.
9. Select the desired start time in minutes using "
" or " ".
10. Press " ".
– Wait until the ventilation setting , e.g. " 3 ", starts
blinking.
11. Select the desired ventilation level using
" " or " ".
12. Press " " to return.
13. Programme the next ventilation programme if
required.
– Repeat steps 1 to 12.
The default ventilation program will be load-
ed again if a Factory Reset is given.
2.3.7 Setting extra programmes
Some P menus in the CC Ease panel can be used
to:
• Read the status of various ventilation pro-
grammes;
• Set time delays for various ventilation pro-
grammes on/off;
• Set time delays for various ventilation pro-
grammes.
The user can only use P menus P1, P2 and
P9 to set additional programmes. The re-
maining P menus (P3 to P8) are for use by
the installer only.
Accessing the P menus
1 Press and hold " " and " " for 2 seconds
simultaneously.
– Wait until the "P menu" appears on the display.
2. Select the desired P sub-menu using "
" or "
", e.g., P menu “
2
".
3. Press " ".
4. Select the desired P sub-menu using " " or "
", e.g., P sub-menu "
23
".
5. Press " ".
Entering settings in P menus
The minimum and maximum values for the
available ventilation programmes are preset
in the software.
6. Select a new value for the programme using "
" or " ".
7. Press " ".
8. Repeat steps 4 to 7 to set multiple ventilation
programmes in succession.
2