Zeggo GWA_12Z1, User Manual, Page: 5 / 7

GWA_12Z1
REV. 1, 12/17 5
Operation
Power gateway with 12V adapter and system will boot up after about 3 minutes. Observe the heart
LED, it will blink for 5 seconds immediate after successful boot up. Gateway must configured to allow
internet access either via ethernet, WIFI or 3G/4G
to upload data to Zeggo’s portal . LEDs on top of
devices indicates:
Figure 2: LEDs on Top
Table 1: Gateway LED Indication
LED Indication
ON/OFF LED Light on when device powered on
Heart LED
Light on when receive a wireless signal from
remote devices
Globe LED Flashing indicates Internet Access OK
LAN LED
Flashing during transmission between gateway
with local computer
WAN LED
Flashing during transmission between gateway
and external router
WIFI Flashing during transmission in WIFI Mode
Configuration to Send Sensor Data
Important: To setup connection from gateway to cloud for the first time, user must connect computer
to gateway LAN Port via network cable. Open link
https://10.130.1.1 and add exception of the site
if face invalid security certificate issue. Login the inte rface using username “Zeggo” and
password is “password”.
From left manual bar, under the Tool option, click to enter the Gateway
API Key and paste the API key in the API key input column. API key could obtain under client info page
from Zeggocloud Platform. C
lick on ‘Save & Apply’ button . Observe sensor data update on cloud
platform.
Firmware Setting
Before deployment of the gateway in the job site, check the following things to ensure the gateway
running in the best conditions:
Checklists: