ZyPerUHD
AC Mains Connection
The ZyPerUHD Encoder and Decoder units are powered through an external AC/DC converter
unit or via the Ethernet PoE feature.
If PoE is not available, the Encoder and Decoder units must be powered and connected using
the supplied external AC/DC converter. The voltage supplied to the Encoder and Decoder units
from the external supply is 12VDC at less than 1.0A
•
Do not substitute the supplied AC/DC power supply unit with another component.
The overall system compliance is dependent on each of the provided elements
being present and operational.
INFORMATION: The introduction of a foreign, non-ZeeVee element nullifies
any claim of regulatory compliance asserted by ZeeVee.
The AC/DC power supply shall be powered from the appropriately rated AC mains
voltage which allows for a wide range of input, generally from 100VAC through 240VAC.
Only use a power cord with an appropriately rated protective earth connection. The protective
earth connection is essential to the overall safety of the system.
WARNING: Bypassing or omitting the protective earth
connection increases the risk of electrical shock and
radio emissions
Install the equipment in such a manner as the IEC power cord ingress in to the AC/DC adapter
is accessible as this is the boundary of the AC mains system and the point at which the
ZyPerUHD equipment is disconnected from the AC mains power if needed.
The equipment should be installed as near as is practicable to an AC outlet.
•
Do not substitute or extend the DC cable from the AC/DC unit.
The ZyPerUHD system is intended and rated for continuous operation
Should the ZyPerUHD equipment be unused for an extended period of time it should be
disconnected from the AC mains at the AC inlet to the external AC/DC converter in order to
protect the equipment from transient over-voltage conditions.
User Manual
Page
of
23
29
