Page 6
|
ZvPro 800i Configuration Guide
www.zeevee.com
)URQW3DQHO&RQÀJXUDWLRQ
SETUP SCREEN
CONFIGURATION SCREEN
ACTIVE CONFIGURATION SCREEN
You can set the RF broadcast channels or
implement delay matched audio using the front
SDQHOFRQWUROV,QPDQ\FDVHV\RXU=HH9HH
PRGXODWRUZLOOUHTXLUHRQO\WKHVHFRQÀJXUDWLRQV
6HWWLQJWKH5)EURDGFDVWFKDQQHO
RF power or audio delay
1.
Unlock the panel by pressing/holding together
the left and right arrow buttons (
W
X
XQWLO
´6HWXSµOLJKWVXS
2.
3UHVV´2.µWRHQWHUWKH&RQÀJXUDWLRQVFUHHQ
3.
Use the arrow buttons (
STW
X
WRJRWR
HDFKLWHP\RXZDQWWRFRQÀJXUHVXFKDV
5)1XPEHU5)3RZHURU$XGLR'HOD\WKHQ
SUHVV´2.µWRHGLWWKHKLJKOLJKWHGÀHOG8VH
the up and down (
ST
DUURZEXWWRQVWR
VFUROOWKURXJKWKHRSWLRQVIRUWKDWÀHOG
4.
Once you’ve made changes, press “OK” to
accept. You can then select the next item for
FRQÀJXUDWLRQ
5.
:KHQÀQLVKHGPDNLQJFKDQJHVXVHWKH
arrow buttons to scroll down and select
“Apply,” then click “OK” to save your changes.
Note: The front panel locks automatically after
a few seconds. To make more changes, press/
hold the left and right arrow buttons again to
re-enter the setup screen.
7RXSGDWHÀUPZDUH
• If unit is connected to the
internet and can communicate
with our servers, select Update
)LUPZDUHIURPWKH6HWXSVFUHHQ
and press “OK”.
7RUHVHW,3DGGUHVV
• When using DCHP, select Reset
IP Address to force a release/
renew of your IP address, and
press “OK”.
To restore factory defaults or
UHYHUWÀUPZDUH
1.
Power down the unit.
2.
Hold the left and right arrows
down and reapply power. You
will be prompted to a screen:
• Press up arrow to reset to
defaults;
• Press down arrow to revert
ÀUPZDUH
Shows audio/video being encoded
Green — Both audio and video are detected
Yellow — Video, but no audio detected
Red — No video detected
