- 2 -
1.
HOW TO ENTER MENU
PSR
must be connected to the battery, or engine need to run. Connect
programmer
to
PSR
and wait few seconds for activation of
programmer
and then press enter. With pressing +
, or - you can move through menu and select with pressing enter .
Exit menu with selecting
Exit.
2.
MENU ORGANISATION
Load Ign. Curve
- load previously saved ignition curve set (from #1 to #2)
Save Ign. Curve
- save new ignition curve set (from #1 to #2)
Ignition Curve
- ignition curve parameters submenu
Advance
- advance/retard whole ignition curve
Rev Limit
- rev limit
Static Angle
- static angle (stator position)
Compensation
- signal delay compensation (from pickup to spark plug)
Pulses Per Rev
- number pulses per rev from pickup
Exit
3.
LOAD IGN. CURVE
Enter menu and move to
Load Ign. Curve
with pressing + or - and then press enter .
Now you can select position number of previously saved ignition curve set, with pressing +
or - and then press enter .
4.
SAVE IGN. CURVE
Enter menu and move to
Save Ign. Curve
with pressing + or - and then press enter .
Now you can select position number to which you want to save your ignition curve set, with
pressing + or - and then press enter .
5.
Change IGNITION CURVE
Enter menu and move to
Ignition Curve
with pressing + or - and then press enter .
Now you are in submenu for setting ignition curve.
Submenu organisation:
Nr. of Points
- number of ignition curve points (from 4 to 10)
1)
- first ignition curve point
2)
- second ignition curve point
... ...
... ...
Exit Curve
- exit submenu
Important!
To avoid wrong processing, don't make unreasonable curve course.
