Zeegma Zonder Pro Multi, User Manual

Page: 15 / 104

EN
TROUBLESHOOTING
Problem Cause Solution
Dirt / water
escapes from the
telescopic tube.
Accessories were
not fitted correctly.
Make sure accessories
are tightly and
correctly fitted.
Poor suction. Filter / telescopic
tube / hose / inlet
hole is clogged.
•
Clean the filter,
replace the bag
and make sure the
accessories are
not clogged.
•
Check the upper body
and ensure that the
plastic clamps are
properly closed.
The device makes
unusual sounds.
•
Overfilled tank.
•
The device fell
over and the air
inlet was blocked.
•
Remove excess water.
•
Place the device in
an upright position.
Smoke is coming
out of the device.
•
The device is
overheated or
overfilled.
•
Damaged motor.
•
Switch off the device
and remove excess
water. Clean the filter
and replace the bag.
•
Contact the
manufacturer.
Insufficient
filtering.
Filter life is too long. Replace the filter
with a new one.
CLEANING AND MAINTENANCE
1. Switch off and disconnect the device from the power supply
2. Release the metal clamps to open the upper body and pull
out the bag for dry vacuuming.
3. Clean the inside of the tank with a damp cloth and allow to
dry completely.
Note! If dirty, the filter should be washed under running water
and allowed to dry completely. It is recommended to change the
filters regularly.
The photos are for illustrative purposes only, the actual appearance of the
products may differ from those shown in the photos.