5. OPERATING THE HYDRO-WIPER
1 3
OPENING AND CLOSING THE WIPER CONTROL HOUSING
To open the wiper control housing, unscrew the lid in an anti-
clockwise direction. If the lid is tight, use the lid shifting tool
supplied with your Hydro-Wiper. This tool fits into the groove in the
top face of the cap and allows greater leverage.
To close, screw the cap onto the battery housing until it is just hand
tight. Do not over tighten or use the cap shifting tool to tighten the
cap.
NOTE!
Always clean and service the O ring before closing the
lid. Refer to the maintenance section of this manual for
instructions on doing this.
INSTALLING THE BATTERY
Switch the power switch to the off position. Gently pull the battery
connector off the battery holder contacts. Remove the battery
holder from the control housing and insert 6 new AA batteries into
the battery holder. Check all the batteries are correctly orientated.
Put the battery holder back into the control housing. Re-attach the
battery connector to the battery holder contacts. Switch on the
Hydro-Wiper. The LED should flash 4 times and then a wipe is
performed.
NOTE!
Use only good quality AA 1.5 volt alkaline batteries (eg.
Energizer or Duracell brand).
