2D Image On-Counter Scanner
8
2
U
SER
’
S
M
ANUAL
Setting Up the Scanner
In certain cases no setup is required. The scanner is either pre-programmed to suit the
situation, or it automatically detects and is ready to go. In other cases the scanner must
be informed about what kind of system it is connected to. This can be done in a few
moments using the programming barcodes in the
Programming Guide
.
The
Programming Guide
may be used to set a number of parameters on the scanner:
communication interface type (RS-232, USB), beep tone, scan mode, baud rate,
enable/disable decoding of numerous code types, and more advanced settings like set
prefix and suffix.
Individual parameters may be set at any time without affecting the other parameters.
Programming the Scanner
1.
When the scanner is powered on (blue LED lights), find the
Set
barcode in the
Quick Start Guide
or
Programming Guide
and present this barcode to the scanner.
When the scanner gives two beeps, it means the scanner is in programming mode.
2.
Decide which parameters are required and find their barcodes in the
Quick Start
Guide
or
Programming Guide
.
3.
Cover unwanted codes with your hand and present the desired codes, one by one,
to the scanner; the scanner beeps once as it accepts each code.
4.
When done, again present the
End
barcode to the scanner. The scanner beeps
thrice, it means the scanner is out of programming mode. The scanner has been
programmed.
5.
Test again with known-good barcodes. If results are good, you are done setting up.
Otherwise, return to step 1 and try again.
Summary of Contents for Z-8082 Lite
Page 1: ...2D Image On Counter Scanner ...
Page 2: ......
Page 6: ......
Page 18: ...2D Image On Counter Scanner 12 2 USER S MANUAL Dimensions Unit mm Scan Angle ...
