7.0.3 Install new lubricated O-rings(17), onto the QD Tube (16) and then screw the QD Tube into the Lever
Support (22). Screw the two sections together until they are hand tight. This positioning will allow the as-
sembly to slide properly into the Body (25). (See Photo 22)
7.0.4 Insert the Lever/QD
Assembly into the body. As you are inserting the Assembly, carefully line up the flat on the Lever Support
(22) so that it slides into position over the three raised flat flanges. This indexes the position of the tip of the
Lever (20) properly in the Body (25).
19
Photo 22
Photo 22
