9
Need help?
www.zBoost.com
Tech Support 800-871-1612
Mon.- Fri. Hours: 8:30 am to 5:30 pm EST
Copyright © 2014 zBoost All rights reserved.
U.S. Patent Nos.– 7,221,967; 7,729,669; 7,486,929; 7,409,186; 7,783,318; 8,583,034; 8,583,033; 7,684,838; D626,953; 8,473,018
Disclaimer:
The information provided by zBoost is believed to be complete and accurate.
However, no responsibility is assumed by zBoost for any business or personal
losses arising from its use, or for any infringements of patents or other rights of
third parties that may result from its use.
Signal Booster Specifications
zBoost Mobile1
Model Number
ZB245
Connectors
SMA-Female
Antenna Impedance
50 Ohms
Frequency
824-894 MHz/1850-1990 MHz
3
Power output for single cell phone (dBm)
800 MHz
1900 MHz
Uplink
Downlink
22.9
-28.0
25.2
-29.1
Noise Figure (typical downlink/uplink)
3 dB nominal
Isolation
> 40 dB
Power Requirements
5.5 V 1A
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory
reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase
coverage of authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected. If
a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn the
power off on that band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute.
After 5 (five) such automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually restarted by
momentarily removing power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster’s microprocessor.
One Meca Way, Norcross, GA 30093
web:
www.zBoost.com
email:
phone:
877-594-5766
local:
507-282-8484
fax:
866-827-4052
111357_Rev01_04.21.14
