Zaxcom TRXLT3, User Manual

Page: 11 / 35

Zaxcom TRXLT3 Transmit Menu
11
TRANSMIT MENU
UHF Transmitter Power Level Set
The UHF transmit power of the TRXLT3 is set from this page. The transmit power can be adjusted to
output 25 or 50mW. The higher the power setting the more battery power will be required.
UHF Transmit Modulation Set
The UHF transmission modulation is the way the TRXLT3 sends audio to the receiver. The modulation format is
set from this menu. Please note if the transmission format that is set here, and the format set on the receiver
do not match, the receiver will be unable to decode the audio from the transmitter. Also note that after any
change to the transmit format the TRXLT3 will need to be rebooted by pressing the card key before the new
format takes effect.
STEREO MONO XR ZHD 96 ZHD 48
Modulation Bandwidth 200 kHz 200 kHz 200 kHz 96 kHz 48 kHz
Minimum Channel to Channel Spacing 400 kHz 400 kHz 400 kHz 200 kHz* 100 kHz**
6 MHz TV Channel Capacity 15 15 15 30 60
Latency 6ms 3.5ms 6ms 6ms 18ms
Compatibility with a 200 Series Receiver 2 Transmitters 2 Transmitters 2 Transmitters 2 Transmitters 1 Transmitter
Compatibility with a 300-96 Receiver NO NO NO 1 Transmitter 1 Transmitter
Compatibility with a 300-48 Receiver NO NO NO NO 1 Transmitter
* When used with a QRX300-96 receiver – the minimum spacing is 300 kHz when using all other receivers.
**When used with a QRX300-48 receiver – the minimum spacing is 200 kHz when using all other receivers.
Transmitter Disable - Record only mode

Record Only Mode - Will set the TRXLT3 to act as a standalone recorder and will not transmit any audio over
UHF. This will conserve battery power since the transmitter is disabled.

Normal TX Mode - Will allow the TRXLT3 to both transmit audio and record on its internal SD card.
TX POWER: 50MW
TX FORMAT:
ZHD96
PRESS CARD TO REBOOT
TX DISABLE :
NORMAL TX MODE