Zauber MAX-210, Manual

Page: 9 / 34

Page 9 of 36 Zauber MAX-210 © ZAU Grupp 2012 (ENG)
Zauber MAX-210 Bekvämt
Portable Home Steam Station
Dear Customer! We thank you for purchasing the
electric kettle from Zauber. We hope, you are satisfied
with the high quality, functionality and original design
of our products.
Important Safety Precautions
Attention! Please carefully and completely read these
instructions before you start using the device.
1. Do not allow children to use the device itself, or small
children to be close to the instrument in the near
absence of adults.
2. To prevent electric shock do not immerse power cord or
plug in water or other liquid.
3. Power cable and plug must be in good condition and not
be damaged. Do not use damaged or defective cable
and plug. They must be replaced at a service center
4. This product is intended for use only at home and
should not be used for industrial purposes.
5. Do not turn the power on until you fill the tank with
water. To avoid electric shock, never attempt to
disassemble or repair the device.
6. Harakteristika power source must comply with
manufacturer‘s device.
7. When using the neck of the tank must be sealed. The
lid must be securely tightened.
8. Must be used with a special slot grounding wire.
9. When operating the housing should not be tilted at an
angle exceeding 45 degrees. Otherwise, the hot water
will be sprayed with pairing..
Always draw the device vertically from top downwards;
never draw it in the horizontal direction and do not
throw away the steam supply button as it may lead to
water leakage.
10. Do not direct steam at people, animals or other
electrical appliances.
11. Do pouring of water, make sure that the cable is
disconnected. The cable should be disconnected after
the completion of the unit to clean it and repair. During
storage, the cord should be freely folded under the
instrument
12. Do not add solvent tank rust, fragrances, alcohol and
detergents, which can cause damage to the tank.
13. Do not overfill the tank. This can lead to a change in
the generation of steam or vapor pressure is too high.