SECTION 4 - INSTALLATION
23
Zator
Via Galvani, 11 - 20095 - Cusano Milanino (MI) - Italy
www.zator.it - [email protected]
Fluid supply
connection M5
Electrical
connection
*Parts are supplied separately
*Parts are supplied separately
TILT TO FOLLOW
Direction on travel
The valve must be connected to a glue feed units*. A
flexible plastic pipe* (for applications up to 8 bar) must
be connected to a pipe fitting (M5)* to be screwed on
the fluid supply connection of the valve.
For applications with working pressure over 8 bar use
fittings and pipes* for high pressure must be used.
Connect an electrical cable* with cross-section not less
than 0.35 mm to the coil connector. The valve must be
electronically controlled by a Zator’s microprocessor
control or alternatively with an instrument tested and
approved by Zator.
4.3
Contact gluing application
4.4
Fluid supply connection
4.5
Electrical connection
The contact gluing application is used when is necessary to dispense very thin glue lines.
In this case the valve must always be positioned vertically, with the nozzle facing downwards but with
an inclination of 7 ÷ 8° with respect to its axis towards the direction of travel and the nozzle must lightly
touch the surface to be glued.
7 ÷ 8°
7 ÷ 8°
