Zato CAYMAN FCE II Series, Safety, Operation And Maintenance Manual

Page: 29 / 96

29 / 96
CAYMAN
Version 01 - Revision 00
09/05/2017
4.4
GENEral opEratING prINCIplEs
The shears rotate by 360° on the slewing ring via the hydraulic motor in the rotating unit, which is integrated
into the machine arm, secured via the linkage connection� The linear movement of the cylinder shaft, driven
by the machine‘s hydraulic pressure, causes the upper jaw of the shears to rotate on the central pin�
4.5
INtENdEd usE
The equipment is intended for demolition work and shearing of structural elements, as shown in the following
table�
Intended use allowed material
shearing
Cutting
Ferrous material
tab. 3 Intended uses
4.5.1
Number of workers
1 Only operator is required to use the attachment�
Depending on the type of work to be done, a second operator on the ground may be necessary� This is up to
the Customer’s discretion and is the Customer’s exclusive responsibility�
If there is an operator on the ground, he/she must stand at least 25m from the machine’s
range of action during all the operations.
4.5.2
operating limits
The attachment must be used following:
∂ the specifications reported in “4.7 specifications” on page 30 ;
∂ the specifications reported in the documents accompanying this Manual�
If the attachment is supplied together with the machine, please refer to the operating limits
indicated in the Installation, use and Maintenance Manual of the machine itself.