Zato CAYMAN FCE II Series, Safety, Operation And Maintenance Manual

Page: 30 / 96

30 / 96
CAYMAN
Version 01 - Revision 00
09/05/2017
4.6
IMpropEr usE
Any use of the attachment other than what is described in “4.5 Intended use” on page 29 must be
authorised in advance in writing by the Manufacturer�
do not use the attachment for processes that are not permitted by the regulations in force in
the Country where the machine is installed and used�
do not hit the attachment on the ground�
do not use the attachment as a pivot to rotate the machine�
do not use the attachment to lift people, things, and/or animals�
do not tear and/or pull structures or things that should be cut�
do not push and/or hammer any type of structure�
do not shear/cut tempered or hardened steel material�
do not cut structural elements with shapes or dimensions such to pose a hazard in terms of the
possible movements generated on the part or structure�
4.7
spECIfICatIoNs
4.7.1
hydraulic features
using the attachment with oil flows exceeding the indicated intervals can damage the
attachment itself.
The hydraulic features of the attachment by model are shown in the table below�
Model
operating pressure
(cutting)
operating pressure
(rotation)
recommended
capacity (cutting)
recommended
capacity (rotation)
FCE06R-II 350 bar (max) 100 bar 100 - 150 l/min 28 l/min
FCE10R-II 350 bar (max) 100 bar 150 - 180 l/min 25 l/min
FCE20R-II 350 - 380 bar 100 bar 150 - 180 l/min 28 l/min
FCE30R-II 350 - 380 bar 100 bar 200 - 250 l/min 28 l/min
FCE40R-II 350 - 380 bar 110 bar 250 - 300 l/min 28 l/min
FCE50R-II 350 - 380 bar 110 bar 350 - 400 l/min 45 l/min
FCE70R-II 350 - 380 bar 140 bar 550 - 600 l/min 50 l/min
FCE90R-II 350 - 380 bar 160 bar 650 - 700 l/min 60 l/min
tab. 4 Hydraulic features
Using the attachment with oil flows below the indicated intervals affects the attachment
performance�