6
CHANNEL EDIT
PC Program:
Connect the program cable to the radio, and well connect the com-
puter COM (communication port) and SP/MIC jack by program cable,
turn on the radio at the same time.
Turn on the computer, and open the radio program soft. Then se-
lect the using frequency and other function parameters which you re-
quired, Afterward, press the
[ Edit ]
[ write to radio ]
, or directly press
the relative signal on the toolbar to start writing. After the progress bar
fi nished, the screen will display
[ Succeed ]
. All the parameters on
the screen have written in the radio.
Wire Copy:
Take out a programmed radio, while using a special data copy cable
to connect to another radio which you want to copy data.
The radio was copied should turn to channel 8. Press
[PTT]
but-
ton and
[Function]
button, and switch on the radio at the same
time you will hear a beep in 5 seconds; release the
[Function]
but-
ton. The red light will on, which means under the copy mode.
Using a special data copy cable to connect the SP/MIC jack of two
radios. Firstly, turn on the coping radio,
While everything is ready, the copied radio is light on, Press the
[MONI]
button to enter copy mode, the light of copied radio will
shows red and fl ash, the light of coping radio will shows green and
fl ash. The light of copied radio will shows red while the copy has
fi nished.
Summary of Contents for T30
Page 18: ......
