ZA-725 User Manual
24
ZA-725 User Manual
23
Factory programmed on English.
PTT ID
Each radio can be allocated with a 15 digit ID consisting of digits 0-9 or
A,B,C or D. The PTT ID recognition signal can be set per channel or the side
key can be programmed to activate / deactivate it. The radio can be
programmed to send the ID either at the beginning and/or end of a
transmission. The PTT ID or automatic number identification (ANI) is used to
connect with a repeater or telephone system, or for a control centre’s
communication management to identify this caller’s ID using other radios
equipped with a DTMF Decode function.
Begin of Tx:
The radio will send out the ID first before allowing voice
communication once the PTT key is pressed.
End of Tx:
The radio will send out the ID at the end of a communication once
the PTT key is released.
Both:
The radio will send out the ID first before and after the PTT key is
pressed.
Scramble
Scrambler can be set per channel or the side key can be programmed to
activate / deactivate it. Scrambling technology use a coded algorithm to
invert the audio signal and make it unintelligible unless the other radio also
has the same descramble function. This function is used to achieve extra
privacy on the same channel.
Compander
A compander can be set per channel or the side key can be programmed to
activate / deactivate it. The compander will make communication more clear
by improving the ‘Signal to Noise Ratio’ using compression and amplification
technology and decrease the noise when receiving a signal.
Power Selection (only in dealer license version)
Maximum communication range is achieved when the transceiver is set to
high power mode, whilst lower power settings will save battery life. The
power can be set on low (500mW) or High (4W).
Factory programmed on low 500mW.z
delay time can be chosen to suit your style of speaking and avoid the
message breaking up.
SK2 is Factory programmed on VOX, sensitivity level 7 of 9 with a delay
of 1.5 seconds.
Battery Capacity Indication
Either side key can be programmed to enable this function. The remaining
charge on the battery will be voice indicated using a number 1-4. This is
useful in determining when to charge the radio.
4 – Half to Full
100-40%
3 – Medium
39-30%
2 – Semi-low
29-20%
1 – Low
19-0%
Low Battery Alert
When the battery capacity is getting low and indicates a level of “1”, the radio
will alert you with a message “please charge the battery” every 5 seconds
unless the radio is recharged.
Note: If the Voice Announcement function is disabled, the radio will sound a
double beep “di di ” sound when going flat.
Call Ring
The side key can be set to transmit a loud 3 second call ring tone to alert
other radios.
SK1 is Factory programmed on Call Ring, Hold in to activate.
Emergency Alarm
Either side key can be programmed with a siren alert as an emergency
notification. When pressed, the siren will be sounded on both the sending
and receiving radios. The siren will stop once the side key is pressed again,
the sending radio is switched of or the time-out timer limit is reached.
Announce Voice Channel
As the channels are changed, a voice announces the specific channel. This
is useful when using the radio at night. Either side key can be programmed to
activate / deactivate this function.