zarges Z 600 S-PLUS, Assembly And Usage Instructions

Page: 6 / 44

Assembly and usage instructions
6
2. Setup
2.1. Safety provisions
1. The stipulations of EN 1004 “Mobile work platforms” apply to the structural safety,
erection and use of the aforementioned scaffold towers.
2. The scaffold towers may only be set up and used by persons familiar with these
assembly and usage instructions.
3. At least two persons are required to set up or dismantle the scaffold tower. (Applies to
all mobile scaffold towers with a platform height exceeding 2.50m)
4. Undamaged and fault-free original spare parts for
the manufacturer's scaffolding system to which the
test certificate applies must be used. Before using the
scaffold tower, all parts must be examined for correct
assembly and functionality.
5.
max.
12,0 m
max.
8,0 m
Under EN-1004, the maximum platform height is 8 m in
outdoor use and 12 m in completely enclosed spaces. The
maximum platform height for the scaffold towers described in
these assembly and usage instructions is 10 m in completely
enclosed spaces.
6. The use of lifting tackle on the scaffold tower is not permissible.
7. The platforms are each set up with a rung spacing of 7 rungs, afford to be granted to
the secure footing at all times.
8. The scaffold tower may only be set up in vertical position on a horizontal, level surface
of sufficient load-bearing capacity. Where necessary, load-distributing pads must be
used.
9. Chassis beams, ballast weights, stabilisers and stand-off brackets must be used to
ensure structural safety as described in these assembly
and usage instructions.
10. Working on the work platform is only permissible with
full protection on 3 sides, i.e. guard-rail frame, knee
protection and peripheral toeboards. Toeboards are not
necessary on the rest platforms.
11. Working on several work platforms simultaneously is prohibited.
12. When setting up the scaffold tower alongside a wall, stand-off
brackets (accessories, Order No. 42920) can be used in addition to
ballast.
Stop