Zapp Z710i, User Manual

Page: 7 / 48

11 10
USING THE BA
USING THE BA
TTER
TTER
Y
Y
INSTALLING THE BATTERY
1
Insert the bottom of battery into the groove at the bottom of the
handset. Then
2
press in the top of the battery until it snaps.
REMOVING THE BATTERY
Push the tab
1
with one hand and lift the top of the battery
2
to
separate.
NOTE
The battery must be correctly placed in the battery compartment.
If battery is incorrectly inserted, the handset will not turn on or the battery may slip
out during use.
BATTERY SPECIFICATION
Battery:Standard
Charging Voltage:4.2V
Capacity:850mAh
Chemistry:Li-Ion
CHARGING THE BA
CHARGING THE BA
TTER
TTER
Y
Y
POWER CONNECTION
Connect the charger to a standard 100~240 VAC Oultet.
LED Indicator : When travel charger is plugged into wall mount, the LED indicator shall flash
Red, Green and Orange in order within 1second.
Connected to the transceiver, the TCU LED will indicate the charge status of
the transceiver battery pack via the following table.
Off : Transceiver not connected or transceiver connected with no battery.
Flashing Orange : Shorted/Open circuit in cable, phone or battery or output over current or
battery fault
Solid Red:Battery is being charged. Recharging may be active.
Solid Green : Charge cycle is complete (battery is >90% of rated capacity and, trickle
charging may be active) or backup charge may be active.
Solid Orange: The temperature of battery is abnormal.
During charging, LED on the phone and LED on the charger will be Red color.
After finishing Charging, LED on the phone will be off. And LED on the charger will be
Green color.
WARNING!
In case of instant electric power interruption, the travel charge may not function
properly. In this case, please disconnect the travel charger from the wall outlet and
then try charging again after 5 seconds