Zapf Creation BABY born 832691, Manual

Page: 11 / 84

11
Playing with water:
Fill with clear water. Please note the markings.
Only use commercially available bath additives. Do not use chlorine or salt water.
Switch on the item using the ON/OFF switch. A melody plays.
Briefly press the switch with the water droplet symbol.
Water runs out of the shower head for approx. 26 seconds. Pressing the switch again within the 26
seconds stops the shower function.
Briefly press the switch with the light symbol.
The bathtub lights up in various colours for approx. 26 seconds and makes sounds.
Briefly press the switch with the light symbol again within 26 seconds to pause the colour change
function at the desired light colour. Press this switch again to continue the colour change function.
To stop the light and sounds, press and hold the switch with the light symbol (approx. 3 seconds).
The shower function and light function with sound effects can be started at the same time (briefly press
both switches).
To end both functions, briefly press one of the two switches.
Squeeze the rubber duck and hold it under water to fill it with water.
Once it has been filled, the water can be sprayed out of the end of the duck’s beak by squeezing it again.
Do not spray water at people or animals. Do not spray water at electrical devices or systems.
Danger to life!
Following use, the duck must always be emptied completely and left to dry in a warm and well-
ventilated place for an extended period.
After playing with the product, empty the water in a suitable place and leave the item to dry in a
warm, well-ventilated place for an extended period.
Playing without water:
Switch on the item using the ON/OFF switch. A melody plays.
Briefly press the switch with the water droplet symbol.
A shower sound can be heard for approx. 26 seconds. The pump does not start.
Briefly press the switch with the light symbol. The bathtub lights up in various colours for approx. 26
seconds.
Briefly press the switch with the light symbol again to pause the colour change function at the desired
light colour.
Press and hold down the switch with the light symbol to switch off the light and sound effects.
Briefly pressing both switches at the same time activates the sound of running water and the colour
change function for approx. 26 seconds.
Cleaning and drying
• The product can be wiped using a damp (not wet) cloth. Make sure that no moisture enters the
battery compartment or the electronics.
After use with water:
• If bath additives were used, always thoroughly rinse the product with clear water.
• Use a cloth to wipe the product dry on the inside and outside.
• Allow it to drain and dry in a warm and well-ventilated place.
Information:
• Water inside the hollow wall of the bathtub can drain out of the openings on the base. Please place
it on a suitable surface and allow to drain and dry completely.
• Do not leave the item in direct sunlight for an extended period of time.
• Do not expose the item to high temperatures of more than 48°C.
• If the light fades or flickers, check and, if necessary, replace the batteries.
• If the pump performance deteriorates, check and, if necessary, replace the batteries.
• The light and pump performance depends on the battery type.