• The indicator of the button
stops to
flash and stays on.
• The programme starts, the lid locks, the
indicator
is on.
• The drain pump can operate for a short
time at the beginning of the washing
cycle.
After approximately 15 minutes from
the start of the programme:
• The appliance adjusts
automatically the programme
duration agree with the laundry
load.
• The display shows the new value.
Starting a programme with the Finish In
option
1. Touch the button again and again to
choose the number of hours in which you
want the washing cycle to be finished.
The display shows the number of hours you set
(e.g.
) and the indicator above the button
is on to show that his option is active.
2. Touch the button
:
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the Finish In option before you touch
the button
. After touching the
button
you can only cancel the
Finish In option.
To cancel the the Finish In option:
a. Touch the button
to set the
appliance to pause. The indicator of
button
flashes.
b. Touch the button until the indicator
above this button goes off.
Touch the button
again to start the
programme immediately.
When using liquid detergents in
combination with the Finish In
option, add the liquid detergents
with a dosing ball (supplied by the
detergent's manufacturer).
Interrupting a programme and changing
the options
You can change only some options before they
operate.
1. Touch
.
The indicator of this button flashes.
2. Change the options. If you change any
option the Finish In option (if set) will be
disabled.
3. Touch
again.
The programme continues.
Cancelling a programme
1. Press the button for some seconds to
cancel the programme and to deactivate the
appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water.
In this case, make sure that the
detergent is still in the detergent
compartment, if not fill the detergent
again.
Opening the lid
While a programme (or the ) operates, the
appliance lid is locked. The indicator
is on.
CAUTION!
If the temperature and level of the
water in the drum are too high, you
cannot open the lid.
To open the lid during the first minutes of
the cycle (or when the operates) :
1. Touch the button
to pause the
appliance.
2. Wait a couple of minutes until the indicator
goes off.
3. You can open the lid.
4. Close the lid and touch the button
again. The programme (or the )
continues.
At the end of the programme
• The appliance stops automatically.
www.zanussi.com
11
Summary of Contents for ZWQ 61015WA
Page 38: ...38 www zanussi com ...
Page 39: ...www zanussi com 39 ...
