Zanussi ZWF 01486ZS, User Manual

Page: 12 / 24

A
When the flap is in posi-
tion B and you want to
use powder detergent:
1. Remove the drawer.
2. Adjust the flap in po-
sition A.
3. Put back the drawer
in the recess.
• Measure out the detergent and the fabric condi-
tioner.
• Put the detergent and the fabric conditioner into
the compartments.
• Carefully close the detergent drawer.
ACTIVATING THE APPLIANCE
Press and hold for a couple of seconds the
button to activate or deactivate the appliance.
A tune sounds when the appliance is activated. The
appliance performs a start up animation. The
animation quickly shows each washing programme
and the default temperature and spin settings.
The display shows the word On.
SETTING A PROGRAMME
1. Touch the programme button and set the
programme:
• The indicator of the button flashes.
• The display shows the programme duration.
2. If necessary, change the temperature and the
spin speed or add available options. When you
activate an option, the indicator of the set
option comes on.
If you set something incorrect, the
display shows the message
.
STARTING A PROGRAMME WITHOUT THE
FINISH AT OPTION
Touch the button .
• The indicator of the button stops to
flash and stays on.
• The programme starts, the door locks, the
indicator is on.
• The drain pump can operate for a short time
at the beginning of the washing cycle.
After approximately 15 minutes from
the start of the programme:
• The appliance adjusts automatically
the programme duration agree with
the laundry load.
• The display shows the new value.
STARTING A PROGRAMME WITH THE
FINISH AT OPTION
Check if the appliance has the correct hour set.
See in "Clock setting" how to set the appliances's
clock.
First set the programme (and add options) then set
the option .
1. Touch the button to set the desired end
time. With the first touch the time is rounded to
the nearest hour or to the nearest half an hour.
By each next touch the end time increases by
30 minutes segments until maximum range of
20 hours.
1)
The display shows the finish hour you set (e.g.
) and the indicator is on to show that
this option is active.
2. Touch the button
:
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically and the
actual programme duration counts down in
minutes until the cycle end.
You can cancel or change the set of
the option before you touch the
button
. After touching the button
you can only cancel the option .
To cancel the Finish At option:
a. Touch the button to set the appliance
to pause. The indicator of button
flashes.
b. Touch the button again and again until
the indicator goes off from the display.
Touch the button again to start the
programme immediately.
1) If you keep the button pressed the digits change in a quicker way.
12