Zanussi ZWD 81463 W, User Manual

Page: 3 / 28

•
The ventilation openings in the base (if applicable) must not be
obstructed by a carpet.
•
Ensure you have good ventilation in the installation room to
avoid the back flow of gases into the room from appliances
burning other fuels, including open fires.
•
Exhaust air must not be discharged into a flue which is used for
exhausting fumes from appliances burning gas or other fuels (if
applicable).
•
The operating water pressure (minimum and maximum) must be
between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa).
•
Obey the maximum load volume of 8 kg (refer to the
“Programme chart” chapter).
•
The appliance is to be connected to the water mains using the
new supplied hose-sets. Old hose sets must not be reused.
•
If the supply cord is damaged, it must be replaced by the
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
•
Wipe away lint that has accumulated around the appliance.
•
Items that have been soiled with substances such as cooking
oil, acetone, alcohol, petrol, kerosene, spot removers,
turpentine, waxes and wax removers should be washed in hot
water with an extra amount of detergent before being dried in
the wash dryer.
•
Do not use the appliance if industrial chemicals have been used
for cleaning.
•
Do not dry unwashed items in the wash dryer.
•
Items such as foam rubber (latex foam), shower caps,
waterproof textiles, rubber backed articles and clothes or
pillows fitted with foam rubber pads should not be dried in the
wash dryer.
•
Fabric softeners, or similar products, should be used as
specified by the fabric softener instructions.
•
Remove all objects from pockets such as lighters and matches.
•
Never stop the wash dryer before the end of the drying cycle
unless all items are quickly removed and spread out so that the
heat is dissipated.
3