If you do not intend to carry out another wash, close the
water tap. Leave the door open to prevent the formation
of mildew and unpleasant smells.
If you open and then close the door before turning
the selector dial to “ O ” all the lights corresponding
to the phases making up the performed programme come
on.
After each use
• Clean the filters.
• Empty the water reservoir.
Cleaning and maintenance
Cleaning lint filters
To ensure that the appliance works perfectly, the lint filters
in the door and in front of the drum must be cleaned after
every drying cycle.
Caution! Important. Never operate the dryer without
the lint filter or with a damaged or blocked lint filter.
1. Open loading door
2. After a period of time, a
patina due to detergent
residue on laundry forms
on the filters. Then clean
the filters with warm water
using a brush. Remove the
filter from the door pulling
it out.
3. Use a damp hand to
clean the micro- fine filter,
which is built into the low-
er part of the loading aper-
ture.
4. Remove fluff from lint
filter, preferably using a
damp hand for this pur-
pose.
Replace the filter.
Cleaning heat exchanger
Clean the condenser when light Condenseur (Condens-
er) comes on.
The condenser is situated at the lower part of the cabinet
behind a small door.
1. To open the door, push
the catch as per picture.
During the drying cycle or
at the end, it is normal for
water to be present on the
surface of the condenser
insertion.
2. Turn the two red stops
downwards.
10
