Problem
Possible cause
Solution
The temperature in the appli-
ance is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower tempera-
ture.
The door is not closed correct-
ly.
Refer to "Closing the door".
The food products' tempera-
ture is too high.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Many food products are stored
at the same time.
Store less food products at the
same time.
The door has been opened of-
ten.
Open the door only if necessa-
ry.
Replacing the lamp
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the
illustration).
3. Replace the used lamp with a new lamp of
the same power and specifically designed
for household appliances (the maximum
power is shown on the lamp cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Installation
WARNING!
Refer to Safety chapters.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate
class
Ambient temperature
SN
+10°C to + 32°C
Climate
class
Ambient temperature
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
www.zanussi.com
23
