10
Instrucciones para el
empotramiento
Dimensiones del hueco
Altura 1780 mm
Profundidad 550 mm
Anchura 560 mm
Durante el trasporte la puerta del aprato est‡
fijada con pernos. Quitar el perno superior e
inferior, segœn el sentido de apertura de la
puerta.
Para una adecuada ventilaci—n seguir les
indicaciones de la Fig.
Atenci—n: mantener las aperuras para la
ventilaci—n libres de cualquier obst‡culo.
Es necesario adem‡s que el hueco tenga un
conducto de ventilaci—n con estas medidas:
profundidad 50 mm
ancho 540 mm
50 mm
min.
200 cm
2
200 cm
2
min.
D567
PR01
540
50
B
T H
13mm
D740
¯ 2,5
A
D015/1
¥ Taladrar el mueble con un taladro de punta de ¯
2,5 (penetraci—n m‡xima 10 mm);
¥ Fijar la escuadra en el aparato.
Empujar el aparato en el hueco inasta que el perfil
superior (A) llegue a tope con el mueble.
19
MAINTENANCE
Unplug the appliance before carrying out
any maintenance operation.
Warning
This appliance contains hydrocarbons in its cooling
unit; maintenance and recharging must therefore
only be carried out by authorized technicians.
Periodic cleaning
Clean the inside with warm water and bicarbonate of
soda.
Rinse and dry thoroughly.
Clean the condenser (black grill) and the
compressor at the back of the appliance with a
brush or a vacuum cleaner. This operation will
improve the performance of the appliance and save
electricity consumption.
Periods of non-operation
When the appliance is not in use for long periods,
take the following precautions:
remove the plug from the wall socket;
remove all food;
defrost and clean the interior and all accessories;
leave the door ajar to allow air to circulate to prevent
unpleasant smells.
Interior light
The light bulb inside the refrigerator compartment
can be reached as follows:
- unscrew the light cover securing screw.
- unhook the moving part as shown in the figure.
If the light does not come on when the
door is open, check that it is screwed into
place properly. If it still does not light up,
change the bulb.
The rating is shown on the light bulb
cover.
Defrosting
Frost is automatically eliminated from the evaporator
of the refrigerator compartment every time the motor
compressor stops, during normal use. The defrost
water drains out through a trough into a special
container at the back of the appliance, over the
motor compressor, where it evaporates.
It is important to periodically clean the defrost
water drain hole in the middle of the refrigerator
compartment channel to prevent the water
overflowing and dripping onto the food inside.
Use the special cleaner provided, which you will
find already inserted into the drain hole.
The freezer compartment, however, will become
progressively covered with frost. This should be
removed with the special plastic scraper provided,
whenever the thickness of the frost exceeds 4 mm.
During this operation it is not necessary to switch off
the power supply or to remove the foodstuffs.
Never use sharp metal tools to scrape off frost
from the evaporator as you could damage it.
D037
D411
