A
B
100 mm min
20 mm
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate cor-
respond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power supply
socket is not earthed, connect the appliance
to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
Rear spacers
You can find the two spacers in the bag with
documentation.
Do these steps to install the spacers:
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
2
4
3
1
Levelling
Accurate levelling prevents the vibration and
noise of the appliance during operation. To ad-
just the height of the appliance loosen or tight-
en the two adjustable front feet.
Door reversibility
Important!
To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on
the doors of the appliance during the
operations.
To change the opening direction of the door,
do these steps:
• Remove the plug from the power socket.
• Tilt back the appliance carefully so that the
compressor cannot touch the floor.
• Remove the plinth (1).
• Remove the cap (2) and position it on the
opposite side.
• Unscrew the hinge (3) and remove the door.
10
www.zanussi.com
• Unscrew the lower pin and the washers (3)
• Position the pin and the washers (6) on the
opposite side (7).
• Unscrew the other hinge (5)
1
2
3
8
6
7
• Unscrew the upper pin (4) and screw it on
the opposite side. (5)
• Refit the door.
• Refit and screw both lower hinges.
• Refit the plinth (8).
5
4
• Stand the appliance upright.
• Unscrew the handle (1) and fix it on the op-
posite side (2).
• Re-insert the cover pins (3) on the opposite
side.
3
1
2
Do a final check to make sure that:
• All screws are tightened.
• The edges of the doors run parallel to the
side edge of the appliance.
• The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
It is advisable to wait at least four hours before
connecting the appliance to allow the oil to
flow back in the compressor.
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the cab-
inet. In that case, wait for the natural fitting of
the gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest Af-
ter Sales Service Force. The After Sales Serv-
ice specialist will carry out the reversibility of
the doors at your cost.
11
www.zanussi.com
