A
B
100 mm min
20 mm
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate cor-
respond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power supply
socket is not earthed, connect the appliance
to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
Rear spacers
You can find the two spacers in the bag with
documentation.
Do these steps to install the spacers:
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
2
4
3
1
Levelling
Accurate levelling prevents the vibration and
noise of the appliance during operation. To ad-
just the height of the appliance loosen or tight-
en the two adjustable front feet.
Door reversibility
Important!
To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on
the doors of the appliance during the
operations.
To change the opening direction of the door,
do these steps:
• Remove the plug from the power socket.
• Tilt back the appliance carefully so that the
compressor cannot touch the floor.
• Remove the plinth (1).
• Remove the cap (2) and position it on the
opposite side.
• Unscrew the hinge (3) and remove the door.
10
www.zanussi.com
