12
Residual Heat Function
When a Cooking Duration time is set, the heating
elements of the oven will automatically go off a few
minutes before the end of the programmed time, and the
oven will use the residual heat to finish your dishes
without energy consumption. All current settings will be
displayed until the Cooking Duration time is over.
This function will not operate when the Cooking Duration
time is less than 15 minutes.
Error code
The Oven Electronic Control does a continuous diagnostic
check of the system. If some parameters are not
correct, the control unit will stop the activated functions
and the corresponding error code (letter “
E
” followed by
number digits) will be displayed.
For further details, refer to chapter “
Something not
working
”.
"Demo" mode
This mode is intended to be used in the shops to
demonstrate the oven functionality without any power
consumption except the oven lamp. To activate this
function the appliance should be off.
1. Press button
and “ “ at the same time for
approximately 2 seconds (Fig. 22). The Electronic
Control beeps once.
2. When you press button
to switch on the oven, the
message "DEMO" appears on the upper section of the
display (Fig.23). You can then select any cooking
function, but the oven will not heat up. The thermometer
symbol will come on
, but it will not flash nor rise.
To disable the demo mode:
Press button
to switch off the oven, then press button
and “ “ at the same time for approximately 2
seconds. The Electronic Control beeps once and the
oven is ready to operate.
Fig. 22
Fig. 23
"Beep" Mode
You can choose to make The Electronic Control beep
each time that a button is pressed.
To enable this function, the oven must be off.
1. Press buttons
and " " at the same time for about
3 seconds. The Electronic Control beeps once (Fig.24).
To disable the "Beep" Function:
1. If the oven is on, press button
to switch it off.
2. Press buttons
and " " at the same time for about
3 seconds. The Electronic Control beeps once
Fig. 24
