Warning!
Do not squeeze the gas supply
ramp and the pipe when you move the
oven into the built-in cabinet.
Adjustment to different types of gas
Warning!
Let only an authorized person
do the adjustment to different types of gas.
This appliance is for operation with natural
gas. G20 20G20 20
With the correct injectors, you can also operate
it with another type of gas (refer to "Gas oven
Burner Data").
The gas rate is adjusted to suit.
Replacing the gas oven burner injector:
B A
1.
Remove the bottom plate of the oven cavity
(
A
) to get access to the gas oven burner
(
B
).
2.
Release the two screws (
C
), which keep
the gas oven burner in position.
3.
Carefully move the gas oven burner off the
injector support (
D
).
Slowly move it to the left side. Make sure
that the gas oven burner bush stays on the
burner mouthpiece. Do not apply force to
the wire of the spark plug connector (
F
)
and to the thermocouple conductor (
E
).
4.
Unscrew the gas burner injector (
D
) with a
7 mm socket spanner and remove it. Re-
place it with the necessary one (see table
„Gas Oven Burner Data“).
5.
Assemble the gas oven burner in opposite
sequence.
6.
Replace the gas type sticker near the gas
supply ramp with the one related to the
new gas type (supplied with the injector
kit).
Warning!
A primary air adjustment of the
gas oven burner is not necessary.
Minimum level adjustment of the gas oven
burner:
1.
Disconnect the mains plug from the mains
socket.
2.
Turn the control knob to the minimum posi-
tion and remove it.
3.
Adjust the adjustment screw (
A
) with a thin
bladed screwdriver.
A
Change of type of
gas
Adjustment of the
adjustment screw
from natural gas to
liquid gas
fully tighten the ad-
justment screw in
from liquid gas to nat-
ural gas
release the adjust-
ment screw approxi-
mately 1/2 of a turn
4.
Attach the gas oven control knob.
5.
Put the mains plug into the mains socket.
Warning!
Only put the mains plug into the
mains socket when all parts are put back
into their initial position.
6.
Light the gas oven burner (see section
„Gas oven cooking - Ignition of the oven
gas burner“).
7.
Set the gas oven control knob to 240 and
let the oven heat for 10 minutes minimum.
16
www.zanussi.com
Summary of Contents for ZOG11311
Page 1: ...EN User manual Oven ZOG11311 GB ...
Page 19: ...19 www zanussi com ...
