29
Terminal block
The oven has an easily accessible terminal block,
which is meant to work with an electric single-phase
rate of 220-230 V.
The manufacturer disclaims any
responsability should all the safety
measures not be carried out.
Electric Connection
Before the appliance is connected:
1) check that the main fuse and the domestic
installation can support the load;
2) check that the power supply is properly earthed in
compliance with the current rules;
3) check the socket or the double pole switch used
for the electrical connection can be easily reached
with the appliance built in the forniture unit.
This appliance is provided with connection cable. A
suitable plug must be fitted, in compliance with the
electric supply rate and able to carry the load
specified on the rating plate. The cable is a three-
wired one, with the earth wire marked yellow-green.
When replacing the connection cable, choose the
cable type from the following:
—
H07 RN-F
—
H05 RN-F
—
H07 RR-F
—
H05 VV-F
The plug has to be fitted in a proper socket.
If connecting the appliance directly to the electric
system, a double pole switch must be installed
between the appliance and the electricity supply, with
a minimum gap of 3 mm. between the switch contacts
and of a type suitable for the required load in
compliance with the current rules. The earth wire
must not be interrupted by the double switch pole.
The connection cable has to be placed in order that, in
each part, it cannot reach a temperature 50
°
C higher
than the room temperature.
After the connection is carried out, test the heating
elements for about 3 minutes.
