ZANUSSI
21
Installation instructions
Warning:
If microwave is used, please make sure
there are no inappropriate objects
inside of the oven, including wire racks
or griddles that are the part of
appliance and shall be used solely with
grill or oven functions.
Before installation
Check that the input voltage
indicated
on the characteristics plate is the same as
the voltage of the power outlet you are
going to use.
Open the oven door and
take out all the
accessories
and remove the packing
material, including the white polystyrene
part that holds the turntable plate.
Do not remove the mica cover
on the
ceiling of the interior! This cover stops fat
and pieces of food damaging the
microwave generator.
Warning!
The front surface of the oven
may be wrapped with a
protective film
.
Before using the oven for the first time,
carefully remove this film, starting on the
inside.
Make sure that the oven is not
damaged in any way.
Check that the
oven door closes correctly and that the
interior of the door and the front of the
oven opening are not damaged. If you find
any damage contact the Technical
Assistance Service.
DO NOT USE THE OVEN
if the power
cable or the plug are damaged, if the oven
does not function correctly or if it has been
damaged or dropped. Contact the
Technical Assistance Service.
Put the oven on a flat and stable surface.
The oven must not be put close to any
sources of heat, radios or televisions.
During installation, make sure that the
power cable does not come into
contact with any moisture or objects
with sharp edges behind the oven. High
temperatures can damage the cable.
Warning: after the oven is installed you
must make sure you can access the
plug.
Electrical Installation
Electrical installation must be performed
by an electrician qualified in accordance
with the legislation in force.
Before connecting the microwave oven to
the electric mains, check that the voltage
and frequency of the mains matches that
which is shown on the rating plate located
in the cavity front, and on the guarantee
certificate, which should be kept together
with this manual.
The electric connection is made via plug
(where accessible) or via an omnipolar
switch, which is suitable for the intensity to
be tolerated and which has a minimum
gap of 3mm between its contacts, to
ensure disconnection in case of
emergency or when cleaning the
microwave.
The connection should include correct
earthing, in compliance with current
norms.
WARNING: THE OVEN MUST BE
EARTHED.
If the flexible supply cable fitted to the
microwave ever needs to be changed, it
should be replaced by an official After
Sales Service, because it requires special
tools.
The manufacturer and retailers do not
accept responsibility
for any damage
that may be caused to people, animals or
property if these installation instructions
are not observed.
