51
CONTENTS
Warnings
50
Use
52
Cleaning the interior
52
Use of the freezer - Starting
52
Temperature regulation
52
Quick-freezing
52
The temperature alarm light
53
Internal temperature
53
Freezing fresh food
53
Storage of frozen food
53
Thawing
53
Ice-cube production
53
Use of the refrigerator - Operation
54
Temperature regulation
54
Fresh food refrigeration
54
Air circulation
54
Movable shelves
55
Positioning the door shelves
55
Use and features of the ÇCRISPÕN FRESHÈfilter 55
Cleaning the filter
55
Hints
56
hints for refrigeration
56
Hints for freezing
56
Hints for storage of frozen food
56
Maintenance
57
Periodic cleaning
57
Periods of no operation
57
Interior light
57
Defrosting
57
Customer service and spare parts
58
Installation
59
Location
59
Electrical connection
59
Changing the opening direction of the doors
60
Instructions for totally built-in
60
¥
Do not place carbonated or fizzy drinks in the
freezer as it creates pressure on the container,
which may cause it to explode, resulting in
damage to the appliance. Do not use a
mechanical device or any artificial means to
speed up the thawing process other than those
recommended by the manufacturer. Never use
metal objects for cleaning your appliance as it
may get damaged.
Installation
¥ During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the relevant
Figure.
Attention: keep ventilation openings clear of
obstruction.
¥ Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Important:
if the supply cord is damaged, it must
be replaced by a special cord or assembly
available from the manufacturer or its service
agent.
¥ There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
¥ Parts which heat up should not be exposed.
Wherever possible the back of the product
should be against a wall.
¥ If the appliance has been transported
horizontally, it is possible that the oil contained in
the compressor flows in the refrigerant circuit. It
is advisable to wait at least two hours before
connecting the appliance to allow the oil to flow
back in the compressor.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from municipal
authorities. The materials used on this appliance
marked by the symbol
are recicable.
