Zanussi ZHT 610, Instruction Booklet

Page: 12 / 20

12
A: Built-in Electric Hob: 650mm minimum clearance
B: Built-in Gas hob: 700mm minimum clearance
C: Slot-in Electric Cooker: 685mm minimum clearance
D: Slot-in Gas Cooker:
787mm minimum clearance
Hob
Clearance Height
A minimum clearance height of 650mm (25 1 /
2
”) is
required when installed above a built-in electric hob, or
700mm (27
1 /
2
”) when installed above a built-in gas hob.
A minimum clearance height of 685mm (27”) is required
when installed above a slot-in electric oven, or 787mm
(30
1 /
2
”) when installed above a slot-in gas oven.
When installed between adjoining wall cabinets, the wall
cabinets must not overhang the hob and the distance
between the underside of the cabinet and the worktop
must be 450mm. If the height of the wall cabinet is less
than 450mm, a gap of 50mm must be maintained either
side of the hob.
This cooker hood must not be installed above
a cooking appliance with a high level grill.
Unpacking
The fittings supplied to install this cooker
hood can be found with the instruction book
inside the packaging and consists of the following:
Ducting spigot
Blanking plate
Wall / suspended fixing template
Wall Fitting
The cooker hood is fitted to the wall using the
keyhole slots in the back of the hood.
1. Mark the position on the wall for the two
Ø 8mm dia screw holes (A) as illustrated in the
drawing opposite at 568mm.
2. Check that the hole distances are correct and
are level using a spirit level.
3. At this stage it is important to allow 25mm (1”)
clear space above the cooker hood to enable it
to be hooked onto the screws and for subsequent
removal for decorating or servicing.
4. Insert the screws and tighten to a distance of
5mm.